For example, if we did not want to see any of the invisible walls used to separate out sections of the plan, we could scroll down to Walls, Invisible and remove the check from the Disp column. Check Partition Wall to prevent walls of this type from cutting through the surface layers of floors, ceilings, and other walls.Note: The Layer Display Options dialog is also where we can turn off the display of certain objects.A positive value offsets toward the exterior a negative value offsets toward the interior. Specify a Foundation Offset value to offset the Main Layer of a foundation wall on the floor below relative to the Foundation to Exterior of Layer setting.Repeat this process for Dimension to Exterior of Layer and Foundation to Exterior Layer to choose which layer you want dimension lines to locate and which layer you would like the foundation built to respectively.If this setting is set to the exterior wall layer, no exterior material will generate to cover the floor platform. Use the Build Platform to Exterior of Layer drop-down menu to select the wall layer whose exterior you would like the program to build the floor platform to.Specify the Brick Ledge Depth, which is the vertical depth of the brick ledge under walls of this type when a Brick material Type is specified for the exterior layer and a monolithic slab foundation is built.On the Wall Properties tab in X15 and newer, or under the Wall Settings section in X14 and prior, specify additional properties related to the wall type.This information is used when exporting to REScheck. On the Wall Properties tab in X15 and newer, or under the Energy Values section in X14 and prior, specify the wall type’s Energy Values.An option to extend exterior layers is also available in X15 and newer versions. On the Layer Properties tab in X15 and newer, or under the Selected Wall Layer Line section in X14 and prior, specify the Line Color, Line Weight, and Line Style of a selected wall layer.Check Air Gap to prevent the selected layer from displaying in 3D views or being calculated in the Materials List.Check Auto Detail as Insulation to generate Insulation boxes in the selected layer when Auto Detail is used in cross section views.Also, specify the Max Girt Length, available in X14 and newer versions. When this is checked, specify the Bottom Run Elevation, which is measured from the center of the lowest horizontal framing member relative to zero, the default top height of the subflooring on Floor 1. Check Horizontal Framing to produce framing that runs horizontally instead of vertically, sometimes referred to as girts.These options are not available in X13 and prior versions. Set your Top and Bottom Plate Count and Width, as well as the Max Plate Length.Select the appropriate framing Type from the drop-down menu, the Stud Spacing, as well as the Stud Width. Check Framing to produce framing for the selected layer when wall framing is generated.On the Material Properties tab in X15 and newer, or under the Material Layer section in X14 and prior, specify whether the selected wall layer is marked as Framing, Auto Detail as Insulation, and/or Air Gap. You can also specify the desired Fill Style for a wall layer by selecting that wall layer and clicking its Fill column.Replace the existing value with the thickness that you need.Place your cursor in the Thickness field beside layer 1, which is the outermost wall layer.Repeat step 4 to add as many layers as needed.You can select a wall layer and click Move Up or Move Down to rearrange the wall layers, or you can click the Delete button to remove a layer entirely. This new layer is placed above or below the currently selected wall layer respectively. To the right of the Wall Layers listing, click the Insert Above or Insert Below button to add a new layer to your wall.Replace the wall type name with a short, descriptive name.With the similar wall type selected, click the Copy button at the top of the dialog. A preview diagram of the selected wall type appears in the dialog. Depending on the new wall type you wish to create, you may be able to save time by selecting a similar preexisting wall type from the drop-down list at the top of the Wall Type Definitions dialog.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |